How to get rid of woodworm: 6 methods compared
No single method suits every case. The right choice depends on where the wood is, how deep the larvae are and whether you want to avoid chemicals.
| Method | Reaches larvae inside the wood? | Chemicals | Best for |
|---|---|---|---|
| Surface coating or spray | No, works in the outer layer | Yes | prevention on sound wood |
| Injection into holes | Only around the tunnels | Yes | small, accessible attacks |
| Hot air | Yes, if the core gets hot enough | No | furniture and small items |
| Freezing | Not reliable | No | not recommended for structural timber |
| Microwaves | Yes, up to about 25 cm | No | hidden or installed timber, beams |
| Replacing the wood | Removes the source | No | badly damaged structural parts |
Why treatment is difficult
Larvae live inside the wood, hidden below the surface, so the key question for any method is whether it reaches them.
Surface products and injection
Sprays and coatings soak only a few millimetres into the wood. They help stop new egg-laying but usually do not kill larvae deeper inside. Injecting liquid into the exit holes reaches some tunnels, but the work is slow, the substances are toxic and need protective equipment, and it often has to be repeated.
Heat
Animal proteins set at about 55 to 60 °C, but the core of the wood must reach that temperature and stay there long enough. This works in a chamber for furniture. For a whole roof it means sealing and heating the space for hours, which is demanding and costly.
Freezing
Larvae can protect themselves against very low temperatures and eggs can hardly be killed by cold, so freezing is not a reliable answer for building timber.
Microwaves
Microwaves heat the water in larvae, pupae and eggs, killing them at roughly 55 to 60 °C. There are no chemicals, and the method works up to 25 cm deep, also under paint or cladding. Metal parts in the wood need caution, and the treatment does not protect against new infestation.
Replacing the wood
A heavily eaten load-bearing beam must be replaced or reinforced. A structural engineer should decide.
After treatment
No method guarantees complete success. Keep watching the wood for a season or two, for example with dark paper under the holes, and keep it dry and ventilated.